Independent Research of cell phone jammer

Dial surface and the slider block toggle inclined holes have a gap with 0.5 to mold smoothly. (Δ allocated block struck the surface with the clearance between the slider, B is a block toggle dial face). Allocated block angle α = β ≦ 25 ° (α block to pull angle, β is the angle stop pulling the block). allocated block in the template with the length of the H1 ≧ 1.5W (to ensure that allocated the block strength). S = T +2 ~ 3mm (S required for the horizontal movement of the slider distance; T to undercut the finished product). on the fixed plate thickness H2 ≧ 1.5 D (D for large rod diameter; H2 on a fixed plate thickness). The company manufacturing cell phone jammer has powerful research and development ability.
Set aside a block into the mounting plate on the depth of H ≧ 1/2H2. Sprue bushing head to do a taper so that the mold. And to be mounted on the mounting plate to prevent the machine from the nozzle on the nozzle bushing, resulting in inconvenience to the phenomenon of drawing out, under the influence of an injection. Within the allocated block in the parent template material to escape. Small rod limit stroke S ≦ 2/3H1, to facilitate clamping. (H1 as the height of the slider). Lever positioning of the front slope of the best process, constitute a three-point support, increased allocation of block strength. To successfully pull block assembly, requiring point E at the point D on the right. As shown below. Tilt slider parameter calculation and design features: Due to undercut finished surface is tilted, so the direction of movement of the slider with the finished product undercut slope in the same direction, the side will not strain the finished product. Our company has ability to independently research cell phone jammer.
Generally used in the finished product has slider mechanism, while the direction of motion along the slider also has undercut the finished product, then sales can be used to ramp-up slider. Following picture shows the oblique pin-up slider typical example: S3 = L * tgα (S3 to slide down into the sub-vertical distance B: α for the "T" slot angle: L is the limit screw stroke). S4> S1 + S3 (S4 movement for the stroke seat slider; S1 level undercut distance: S3 to slide into the sub-B distance of horizontal movement distance). β is the angle braces off; δ-bit bracing pin and slider seat space: H for bracing vertical pin inserted into the slider block.