We can customize different cell phone jammer of various frequencies

generally finished Bi for thickness and deep, the side wall core hole bit more pumping, core pulling a larger force, the slider in the running, finished the slider pull may be deformed or strained. Pull the slider to prevent deformation or the finished product is strained, to be played within the thimble in the slide, pull the slider to prevent deformation or the finished product is strained, in the form below (the case when the mold). Our company can independently develop cell phone jammer.
When the product or products the top wall of the inner surface of the inner surface appears upside down, the use of slant is often very effective. The working principle is: the top of the product at the same time restricted by the slope, while for lateral movement, so that products from . Off the top of the ramp is basically a variant of the system, so the design of the first inclined to consider selling out for the top travel EH. Ejection stroke to consider three key elements: the top of the EH must be able to travel out of parting finished top, so the distance must be greater than the height H. finished top of the stroke can not be too long, too long, then will sell off the ramp mold. Therefore, the actual top of the trip must be less than ramp EH sell high. For safety, the designer can install the stopper in the ejector plate to ensure that top out at the top of the range only EH. We can customize different cell phone jammer of various frequencies.
Off the top of the stroke with the oblique angle of the finished product must be able to undercut bit out of the mold, so the actual ejection from the EH * tan (angle oblique pin θ) must be greater than undercut travel S. In order to ensure the finished product off the top of the ramp when the stay in distance from the mold long enough, will not sell out of the mold so inclined, so if the ramp finished off a high LH height H of at least twice the slant angle of up to 7o (subject to the Company equipment capacity limit), usually 5 o, the size of depending on the itinerary and the top of the space may be, sometimes increasing the height of C board to ensure that the ejection. If the finished product (as shown at A) off ramp has been installed in the finished product off the left and right oblique (about 20mm at) Do not install the thimble. Finished on the premises on the top of the ramp off them alone. According to customer’s needs our company can produce the OEM products of cell phone jammer for extensive customers.